9-12 Upgrading Your Server
Installation
Follow the procedure as described below to install 3.5-inch hard disk drives.
1.
Configure the operation mode of hard disk drives according to the manual supplied with
the hard disk drive.
Hard disk drive
First hard disk drive
Second hard disk drive
Third hard disk drive
Fourth hard disk drive
2.
See the section "Preparing for Installation and Removal" described earlier to prepare.
3.
Remove the side cover.
4.
Disconnect the interface cable and power cable from the hard disk drive if connected.
Cage to Install
Serial ATA connector on mother board
Slot 0
Serial ATA connector 0
Slot 1
Serial ATA connector 1
Slot 2
Serial ATA connector 2
Slot 3
Serial ATA connector 3
Mother board
Serial ATA connector 0
Serial ATA connector 1
Serial ATA connector 3
Serial ATA connector 2