Memory Configuration; Pci Configuration - NEC Express5800 User Manual

Memory Configuration

Option
Installed memory
Available under
4GB
DIMM1-4 Status
Memory Retest
Extended RAM
Step

PCI Configuration

Option
PCI Slot 1-4
Option ROM
IMPORTANT:
SCSI controller is connected with the hard disk drive that does not
contain an OS, set the parameter for "PCI Slot x Option ROM" (x: slot
containing the PCI card) to "Disabled".
Parameter Description
– Indicates the total capacity of the base
memory. (View only)
– Indicates the capacity of memory
available in the area under 4GB. (View
only)
Normal Indicates the current memory status.
"Normal" indicates the normal status,
Disabled
"Disabled" indicates a memory error, "Not
Not installed
installed" indicates no DIMM installed,
Error
and
"Error" indicates the system is forcibly
started with memory error. (View only).
Yes Causes BIOS to retest all memory on the
next boot. Automatically reset to "No" at
[No]
the next boot.
1MB "1MB" indicates that the memory test is
done in the unit of 1MB.
[Disabled]
"Disabled" indicates that only memory
initialization is done.
Only pressing Space is acceptable to
suspend the test during the memory test.
Parameter Description
[Enabled]
Displays the submenu to specify whether to
Disabled
enable or disable the BIOS on the device
(board) connected to PCI slot.
Set this item to "Enabled" when the RAID
Controller or SCSI controller is connected
with the hard disk drive which contains an
OS.
Set this item to "Disabled" when the LAN
controller which contains ROM BIOS is
used but the board does not provide
network booting.
Disabling Option ROM Scan saves memory
consumption and time for startup.
If the RAID Controller, LAN board (network boot), or
Configuring Your Server 4-13
Your Setting
[ ]: Factory-set
Your Setting
[ ]: Factory-set