Setting For Solving Problems; Memory Dump (Debug Information) - NEC Express5800 User Manual

5-80 Installing the Operating System with Express Setup

SETTING FOR SOLVING PROBLEMS

Setup the following issue in advance so that your computer can recover from any trouble precisely
and as soon as possible when it should occur.

Memory Dump (Debug Information)

This section describes the procedures for collecting memory dump (debug information) in the
server.
IMPORTANT: Cautions for the Memory Dump
The staff of maintenance service representative is in charge of
collecting memory dump. Customers need only to specify the
memory dump.
If any trouble occur after specifying the process below, the
message to inform that the system is in short of virtual memory
may appear, but continue to start the system. If you restart the
system in such case, memory dump may not be stored correctly.
When the system is Windows Server 2008 R2
Follow the procedure below to specify.
1.
Click Start and select [Control Panel].
The [Control Panel] window appears.
2.
Click [System and Security] and then select [System].
NOTE: If [View by] is not set as [Category], start [System] from
Control Panel directly.
3.
Click [Advanced system settings].
The [System Properties] dialog box appears.
4.
Select [Advanced] tab.
5.
Click [Settings] on the [Startup and Recovery] group box.
6.
Modify [Dump file] in the [Write debugging information] group box, and click [OK].
e.g. Write the debug information in D drive with the file name
"MEMORY.DMP".
D:\MEMORY.DMP