Panasonic WV-SW390 Series Operating Instructions Manual page 138

13 Configure the alarm settings [Alarm]
The VMD areas can be set up to 4 areas for each preset position (
preset positions/
SW396
it will be regarded as an alarm. The camera can be configured to take an alarm action even when the camera
is not at the preset position.
IMPORTANT
•
The alarm occurrence indication button (®page 10) will be displayed when motion is detected by the
VMD function.
•
The alarm occurrence indication button will be displayed when receiving an alarm input of a terminal
alarm or a command alarm.
•
Depending on the network environment, notification may be delayed even when "Real time" is selected
for "Alarm status update mode" on the [Basic] tab of the "Basic" page (®page 49).
•
The motion detection function is not the dedicated function to prevent thefts, fires, etc. We are not
responsible for any accidents or damages occurring in case.
VMD area setting
[Select a preset position]
Select a preset position number to which the VMD area is to be set, and click the [Start] button.
When setting an area which is not at the preset position for the VMD area, select VMD activation in area "except
the preset positions".
VMD information addition
[Information addition]
Select "On" or "Off" to determine whether or not to add VMD information to superimposed image data.
138 Operating Instructions
: maximum 256 preset positions). When motion is detected in the set area,
SC386
SW395 SC385 SC384
: maximum 64