Off-Board Sensor Loop Setup (Dx2010); Figure 26: Rf3227E To Control Panel Wiring; Figure 27: Standard Dx2010 Installation Locations - Bosch DS7200V2-EXP Installation Manual

DS7200V2-EXP | Installation Guide | 2. System Installation
and Setup
2.5.2 RF Receiver to Control Panel Wiring
The RF3227E contains static-sensitive
components. Follow anti-static
procedures when handling this
module.
Wire the RF3227E to the control panel as shown
in Figure 26. When power is applied to the
system, the red LED at the center of the RF3227E
lights.
Figure 26: RF3227E to Control Panel
Wiring
2
R
B
1
G
Y
4
1- RF3227E terminal block
2- Red wire (+) or (R)
3- Black wire (-) or (B)
4- Green data wire (G)
5- Yellow data wire (Y)
6- Control panel board
You can use either one of the Aux Power (-)
terminals and either one of the 12 VDC (+)
terminals when connecting devices to the control
panel.
2.5.3 RF Receiver Programming
See Data Bus Device Parameters on page 99 for
programming instructions.
2.5.4 RF Reciever Supervision
The control panel supervises communication to
the RF receiver. If it fails to communicate with
the RF receiver, it sends a "DBus Missing" {125}
report.
Bosch Security Systems, Inc. | 04/12 | F01U253045-02
3
5
BATT+
BATT-
2.6 Off-board Sensor Loop Setup
(DX2010)
2.6.1 DX2010 (DX2014) Overview
The DS7240V2 supports up to 5 DX2010 Input
Expanders. The DS7220V2 supports up to 3
DX2010 Input Expanders.
Each DX2010 provides eight sensor loops. See
Location ##, Zone Function on page 83 for
information on how the DX2010 sensor loops are
assigned to zone locations.
• DX2014 Input Expander: A DX2010 mounted
inside a plastic enclosure with tamper switch
for remote installation.
• Current Draw without Aux Output
Terminals: 35 mA Standby
• Current Draw with Aux Output Terminals:
135 mA maximum with 100 mA of connected
accessories.
6
2.6.2 DX2010 Installation
The DX2010 contains static-sensitive
components. Follow anti-static
procedures when handling this
module.
Up to three DX2010 modules can be installed in
the control panel's enclosure (two on interior
side walls of enclosure and one on back wall of
enclosure). See Figure 27 and Figure 28 for
installation locations.
Figure 27:
Locations
1
2
1- Control panel board location
2- Standard DX2010 mounting locations
3- DX2010 module
4- Enclosure wall
5- Screws (supplied with DX2010)
Standard DX2010 Installation
3
EN | 23
5
4