Figure 48: Dx4010 Direct Connection; Figure 49: P1 Jumper Pin Settings - Bosch DS7200V2-EXP Installation Manual

DS7200V2-EXP | Installation Guide | 2. System Installation
and Setup
DX4010: Wire the flying leads of the
colored cable connector
(P/N: 15-04298-000 - included with
control panel) to the DX4010's Data Bus
terminals. See Figure 48.
Figure 48: DX4010 Direct Connection
1
6
3
BATT+
BATT-
5
1- Control panel board
2- PC Com port
3- DX4010 Module
4- Null modem cable
5- DX4010 Data Bus cable
6- Control panel AUX/Data connector pin
No additional control panel/module (DX4010i or
DX4010) programming is required to successfully
communicate using the direct connection
method.
Bosch Security Systems, Inc. | 04/12 | F01U253045-02
2
Serial Port
4
2.8.4 DX4010i/DX4010 Configuration Jumper
Pins
The jumpers are located in different
positions on the DX4010i and DX4010
PCB's. However, they function the
same. The figures in this section show
the DX4010i's board.
P1 – DB9 Cable Ground Enable
Some devices connected to the DB9 connector
can cause a ground fault condition on the control
panel. If this occurs, removing the plug across
the P3 jumper pins can clear the ground
condition.
Some devices can cause a ground fault even if
the P3 jumper plug is removed.
Figure 49: P1 Jumper Pin Settings
1
2
1- P3 jumper pin location
2- Isolate DB9 Shield
3- Connect DB9 Shield to Ground
EN | 34
P1
DB9 GND
ENABLE
3