Figure 44: Dx4010I To Control Panel Wiring; Figure 45: Dx4010I To Control Panel Wiring (External Power Supply) - Bosch DS7200V2-EXP Installation Manual

DS7200V2-EXP | Installation Guide | 2. System Installation
and Setup
See Figure 44 and Figure 45 for power wiring
connections.
Figure 44: DX4010i to Control Panel
Wiring
1
1- DX4010i board
2- Control panel board
3- Black (-) wire
4- Green (G) data wire
5- Yellow (Y) data wire
6- Red (+) wire
You can use either one of the Aux Power (-)
terminals and either one of the 12 VDC (+)
terminals when connecting devices to the control
panel.
Bosch Security Systems, Inc. | 04/12 | F01U253045-02
2
4
3
5
6
BATT+
BATT-
If you need to power the module from an external
power supply, connect it to the power supply and
the control panel as shown in Figure 45.
Figure 45: DX4010i to Control Panel
Wiring (External Power Supply)
1
3
6
(+)
1- DX4010i board
2- Control panel board
3- Black (-) wire
4- Green (G) data wire
5- Yellow (Y) data wire
6- Red (+) wire
7- External 12 VDC power supply
You can use either one of the Aux Power (-)
terminals when connecting to the control panel.
Do not tie the black (-) output to
earth ground when using any external
power supply. A ground fault
condition is reported if black (-) is
grounded.
EN | 32
2
4
5
BATT+
(-)
BATT-
7