Toshiba e-STUDIO350 Service Handbook page 26

Error code Classification
EAB0 Finisher jam (Saddle
stitcher unit)
EAC0
EAD0 Other paper jam
EAE0 Finisher jam
EAF0 Finisher jam (Finisher
unit)
EB30 Finisher jam
EB50 Paper transport jam
EB60
ED10 Finisher
(Puncher unit)
ED11
ED12 Finisher
ED13
ED14
ED15
ED16
e-STUDIO350/352/353/450/452/453
ERROR CODE AND SELF-DIAGNOSTIC MODE
Contents
Transport stop jam: The paper which passed
through the inlet sensor does not reach or pass
No.1 paper sensor, No. 2 paper sensor, No.3 paper
sensor or delivery sensor. [MJ-1024]
Transport delay jam: The paper which has reached
the inlet sensor does not pass through the inlet sen-
sor. [MJ-1024]
Print end command time-out jam: The printing has
not finished normally because of the communica-
tion error between the SYS board and LGC board
at the end of printing.
Receiving time time-out jam: The printing has been
interrupted because of the communication error
between the equipment and finisher when the
paper is transported from the equipment to the fin-
isher.
Stack return jam: It cannot load the paper which
passed through the delivery roller on the intermedi-
ary process tray. [MJ-1022]
Ready time time-out jam: The equipment judges
that the paper transport to the finisher is disabled
because of the communication error between the
equipment and finisher at the start of printing.
Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper.
Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper (redetection after no jam is
detected at [EB50]).
Skew adjustment motor (M1) home position detec-
tion abnormality: The Skew adjustment motor is not
at the home position. [MJ-1101 (when MJ-6101 is
installed)]
Sideways adjustment motor (M2) home position
detection error: The Sideways adjustment motor is
not at the home position. [MJ-1101 (when MJ-6101
is installed)]
Shutter home position error: The shutter is not at
the home position. [MJ-1101]
Front alignment plate home position error: The front
alignment plate is not at the home position. [MJ-
1101]
Rear alignment plate home position error: The rear
alignment plate is not at the home position. [MJ-
1101]
Paddle home position error: The paddle is not at the
home position. [MJ-1101]
Buffer tray home position error: The buffer tray is
not at the home position. [MJ-1101]
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
2 - 6
07/11
Troubleshooting
P. 5-48
P. 5-49
P. 5-51
P. 5-51
P. 5-46
P. 5-51
P. 5-11
P. 5-13
P. 5-52
P. 5-52
P. 5-53
P. 5-53
P. 5-54
P. 5-54
P. 5-55