Substep B: Set Up Base Station; Substep C: Set Up Handsets - Toshiba Strata AirLink Installation Manual

Pre-installation
Step 9: Use Stand-alone Base Station Test Stand

Substep B: Set Up Base Station

1. Determine the best location for a Base Station. See
on Page 6
2. Temporarily place the Stand-alone Base Station Test Stand as close as possible to the selected
Base Station location with the proper orientation (vertical or horizontal).
When testing with a Base Station, be sure to rotate all four antennas to a 90° angle.
Note
3. Plug the Base Station power supply into the +5VDC connector of the test stand (located on the
bottom) and into a 110VAC outlet.
4. Watch the LEDs on the front of the test stand until all red LEDs are out and only the green
LED is lit.

Substep C: Set Up Handsets

1. Make sure that your handsets
are fully charged.
2. Press
handset.
3. Enter
access System Configuration.
4. Press
5. Enter
6. Press
7. Enter
8. Press
9. Repeat Substeps 1~8 for each
handset, substituting a
different HID number (for
example, 2, 3, 4, 5, etc.) in
Substep 7.
14
for more information.
3:5
to turn on a
 )&1
and press to
)&1
again.

.
M $%&
(right of ).

.
(1'
.
"Review System Component Placement"
S Y S T E M
C O N F I G
S I D # 0
H I D # 0
The handset returns to idle.
1 2 : 1 5
1 2 : 1 5
1 2 : 1 5
Strata AirLink Installation Guide 5/00