Change Initial Configuration; Change Communications Ports - Toshiba Strata AirLink Installation Manual

RWIU System Installation
RWIU Additional Information
o DMA (four channels and internal to the CPU)
o RTC
The communication with hardware drivers is performed using package interface procedures. The
Init task controls the sequence of card initialization and synchronizes it according to the KSU and
Base Station needs.
System management consists of several packages—each a set of functions providing a group of
services. The main features are:
o Alarm management (send alarm, set alarm severity)
Database services (add Base Station, change status)
o
o Configuration Interfaces (reset Base Station)
o Test Control (set loop back, start test, utilities and general services, such as set date and time,
set LED)
UTAM procedures
o

Change Initial Configuration

It is highly recommended that you get the current configuration and save it to a file on the PC as
the working copy. Then, open and edit the working copy – not the original file. Using this method
ensures that the original configuration file is not corrupted while adding or editing existing data.
Once the new information is saved, the RWIU uses the new data immediately.
Important!

Change Communications Ports

1. From the Desktop Toolbar,
click the Config icon.
2. Click General Settings.
3. Click the new port and OK.
66
Sending configuration information to the RWIU overwrites existing information.
Make sure that the sent data contains all of the required configuration information,
not just the few additions or changes that were made.
The Desktop Toolbar displays.
3348
3349
Strata AirLink Installation Guide 5/00