Step 5: Connect Power Supply; Step 6: Connect Pc - Toshiba Strata AirLink Installation Manual

Step 5: Connect Power Supply

➤
For AC power, use the power supply that comes with the BSIA system. It has a universal input
(110/220VAC), operates at 50~60 Hz, and provides -48VDC.
The power supply includes a cable with a
Note
barrel-jack connection (see
the BSIA and 110VAC cable.
CAUTION!
➤ To connect to power when -48VDC is required
1. For DC power, a power cord with the
following is required:
o 18 AWG wire
o 2.1mm ID x 5.5mm barrel jack (Switchcraft, Inc. S765 or equivalent) with minus (–)
potential center lead and positive (+) shield lead
2. Connect the barrel jack to the BSIA at J1 (see
Battery source requirements are -44VDC to -56VDC @2 amps. An inline, slow-blow fuse
Note
rated 3 amps @250VAC must be installed as close as possible to the battery source on the
minus potential side.
3. To prevent accidental removal of the power cord connected to J1 on the BSIA, tie wrap the
power cord to the power strain relief above the ground screw on the BSIA (see

Step 6: Connect PC

1. Insert one end of the RS-232-C
cable with a DB9 or DB25 adapter
into the serial port in the back of the
PC (see Figure
2. Insert the RJ-45 connector into the
back of the BSIA (J2) (see
22)
Strata AirLink Installation Guide
Figure
Connect to power, but do not
power on until the entire system
is cabled.
21).
Figure
5/00
Barrel Jack
20) to
GND
Figure 20
Figure 20).
RS-232-C Cable
DB9 or DB25 Connector
(Male DB9 or DB25 Adapter)
Figure 21 PC to BSIA Connection
Power Cord Strain Relief
(Circuits 17~32)
J3 J2
J1
-48VDC
Input
Not RJ-45
GND
Used (Admin Port)
Figure 22 BSIA RJ-45 Jack (back side)
BSIA System Installation
Step 5: Connect Power Supply
Power Supply
115/230VAC Input
(50/60 Hz)
+5.3VDC @2.5 Amp Output
Barrel-jack Connection
Figure 22).
RJ-45 Connector (J2 Admin Port)
BSIA
3730
P1
P2
(Circuits 1~16)
25-pair Female Connectors
(Analog Lines and Base Stations)
2983
3000
23