Substep D: Audio Coverage Test; Substep E: Perform Handset Bit Error Rate (Ber) Test - Toshiba Strata AirLink Installation Manual

Substep D: Audio Coverage Test

Strata DK must recognize DTMF signaling, if you have a BSIA. Strata DK requires
Important!
a DTMF receiver PCB to support the RSTU ports.
3:5
1. Press to turn on the handset.
&$//
2. Press .
3. Listen for continuous tone while walking around the facility observing coverage area
boundaries.
4. Mark the floor plan where the continuous tone "warbles" (indicating the beginning of a
handoff overlap area) and where the continuous tone "breaks" or stops (indicating the end of
the coverage area).
(1'
5. Press . The handset returns to idle.

Substep E: Perform Handset Bit Error Rate (BER) Test

1. Simulate real use rather than
trying to get the best readings
by:
Perform tests in all
o
possible areas that users
may carry their
handsets.
Remain in an area long
o
enough to get an
accurate reading. BER
readings can take a few
seconds to register. It is
recommended that you
stand still for an
accurate reading.
Test specific Base
o
Stations. Handsets do
not perform handoff
during BER tests so that
you can test each Base
Station
2. In idle mode, press
$%&
3. Press
Strata AirLink Installation Guide
.
&$//
, then .
5/00
Step 9: Use Stand-alone Base Station Test Stand
B E R
M E A S U R E
1 2 : 1 5
Pre-installation
15