Manually Creating A Network; Authentication Mode - Motorola 7545MBW User Manual

3 - 82 Omnii Hand-Held with Windows CE 6.0 User Manual
Add New: Used to create a new wireless network configuration.
Edit: Used to change values in an already existing wireless network configuration.
Remove: Used to delete a wireless network configuration.
Scan: Used to detect and list available wireless networks. You can highlight a network in the list, and tap on
Add New to activate the network.
There are two methods available when configuring a radio network — you can either scan for an existing
network or manually create a network. If you tap on the Scan button, a list of networks detected by the radio is
displayed. Highlighting one of the listed networks and tapping on the Add New button creates a new profile that
is completed based on the security capabilities detected by the radio. You may need to add additional informa-
tion, depending on your network requirements.

Manually Creating a Network

If you tap on the Add New button rather than the Scan button, you can create a network manually.
IMPORTANT
• Enter the SSID (Service Set Identifier) for your network.

Authentication Mode

The Omnii supports several classes of authentication — Open, WEP, WPA/WPA2 (Personal PSK, Enterprise,
CCKM-WPA, CCKM-WPA2), and 802.1x with EAP. Tapping on the Auth. Mode menu displays your authentica-
tion options.
The steps below describe how to manually create a network. Keep in
mind that this is intended only as an example and may vary from your
own network requirements. If, for example, you are using a different
type of security for your network, the fields you complete may not
match those described here.