Table of Contents
Advertisement
NOTE
As part of the normal Windows Embedded CE cold boot process, the screen
may go blank for a few seconds after the splash screen loading bar reaches the
end. The desktop is displayed after a few moments.
Performing a Clean Start
A clean start returns the Omnii to factory settings, flushes the registry keys, and deletes volatile storage and
the file system. The Flash Disk is preserved.
•
Press and hold down the [FN] key, the [Enter/Power] button and the [SCAN] key simultaneously for a
minimum of six seconds.
The Omnii displays the Boot to BooSt menu.
•
On an alpha keyboard, type .clean.
•
On a numeric keyboard, type .25326.
Boot to BooSt
If you choose Boot to BooSt, the BooSt menu is loaded.
•
Press and hold down the [FN] key, the [Enter/Power] button and the [SCAN] key for a minimum of four
seconds.
•
Press [1] to launch the OS.
Performing a Hard Reset
IMPORTANT
To execute a hard reset:
•
Remove the battery.
•
Using a coin, or other conductive item, connect pins 5 and 6 of the battery contacts for at least six seconds.
•
Replace the battery and power Omnii on. The terminal will boot as if from a cold reset.
Attaching Carrying Accessories
Motorola recommends that a carrying accessory — a hand strap — be installed on the Omnii before use. For
detailed information, please see
This procedure is recommended as a last resort, when all other
methods fail.
"Carrying and Protective Accessories" on page
Pin 6
Pin 5
Basic Operation 1 - 9
4-4.
Advertisement
Table of Contents
Troubleshooting
