Decoded (Internal) Data Options - Motorola 7545MBW User Manual

Code Type
MSI Plessey
D 2 of 5
I 2 of 5
Linear security level 4 requires that all code types be successfully read three times before being decoded.
Bi-Direction Redundancy
NOTE
This parameter is only valid if a "Linear Security Level" is enabled.
When this parameter is enabled, a barcode must be successfully scanned in both directions (forward and
reverse) before being decoded.

Decoded (Internal) Data Options

Transmit Code ID Char
A code ID character identifies the scanned barcode type. In addition to any single character prefix already
selected, the code ID character is inserted between the prefix and the decoded symbol.
When you double-tap on this parameter, a dialog box is displayed in which you can choose a transmit code:
None, AIM or Symbol.
Scan Data Format
This parameter allows you to change the scan data transmission format.
Double-tapping on Scan Data Format displays the following options from which you can choose a data format:
data (as-is), data [S1], data [S2], data [S1][S2], [P] data, [P] data [S1], [P] data [S2] and [P] data [S1][S2].
Prefix [P], Suffix [S1] and Suffix [S2]
A prefix and/or one or two suffixes may be appended to scan data for use in data editing. When you double-tap
on these parameters, dialog boxes are displayed in which you can enter a value from 0 to 255.
Delete Char Set ECIs
Setting this parameter to on enables the scanner to delete any escape sequences representing Character Set
ECIs (Extended Channel Interpretations [also known as GLIs]) from its buffer before transmission.
When this parameter is enabled, the scanner transmits data from PDF417 and MicroPDF417 barcodes
containing Character Set ECIs, even when the ECI Protocol is disabled.
ECI Decoder
Setting this parameter to on enables the scanner to interpret any Extended Channel Interpretations (ECIs)
supported by the scanner. This parameter has no effect on symbols that were not encoded using ECIs.
If this parameter is set to off and a symbol that was encoded using an ECI escape is scanned, the scanner
transmits the ECI escape followed by the uninterpreted data.
The barcode symbologies for the scanner are listed in table following table.
Length
4 or less
8 or less
8 or less
Scanner Settings C - 7