Table of Contents
Advertisement
4 - 18 Omnii Hand-Held with Windows CE 6.0 User Manual
Cleaning the ST4004
IMPORTANT
Use only mild detergent or soapy water on a slightly damp cloth to clean the ST4004. Avoid abrasive cleaners,
solvents or strong chemicals for cleaning. The plastic case is susceptible to harsh chemicals. The plastic is
partially soluble in oils, mineral spirits and gasoline. The plastic slowly decomposes in strong alkaline solutions.
Troubleshooting
The Omnii Charge Indicator LED Stays Off
When the Omnii is docked in a powered ST4004 and the hand-held's charge indicator LED stays off, there may
be a problem with the Omnii or with the docking station. Make sure a battery is installed in the Omnii, otherwise
use an Omnii with a properly functioning charge indicator to isolate the problem.
Power LED Does Not Light Up
•
Remove all Omnii units, and unplug the docking station.
•
Connect another device to the mains outlet to ensure there is power.
•
Remove the IEC mains power cable from the charger, and check it for damage.
•
Reconnect the mains cable in the charger and mains outlet.
The Omnii Charge LED Flashes Yellow
A flashing yellow Omnii charge LED (the left-most LED on the hand-held) indicates that the battery is not within
the allowable charging temperature range – 0° C and 40° C (32° F to 104° F). Allow the battery to come to an
acceptable range before reinserting the Omnii in the docking station.
The Omnii Charge Indicator LED is Red
If the Omnii charge indicator is red when the Omnii is in any of the four bays, the quad dock cannot read the
battery, is in charging timeout, or it is not a Motorola battery.
•
Remove the computers and disconnect the adaptor DC power cable.
•
Wait at least 20 seconds, and then plug the cable in again.
•
If the Omnii indicator still shows a fault, the Omnii requires service.
Powered Adaptor LED Stays Off
•
Check the AC cable. Replace with the same type if the cable is suspect.
•
If the adaptor LED stays OFF, the adaptor is defective and requires service.
Vehicle Cradles - Models ST1000 and ST1002
IMPORTANT
Do not immerse the unit in water. Dampen a soft cloth with mild detergent
to wipe the unit clean.
The vehicle cradles are shipped with their own quick start guide — Omnii
Vehicle Cradles Quick Start Guide (PN 8000221). It is critical that it be
reviewed for additional information and updates.
Advertisement
Table of Contents
Troubleshooting
