Scanners And Imagers - Motorola 7545MBW User Manual

• Use a Phillips screwdriver to remove the SD cover screw. Flip the cover open or remove it.
For a microSD card:
• Slide the microSD card door to the left to unlock it. Flip it open.
• Slide the microSD card into the guides on the SD card door.
• Close the microSD card door, and slide it to the right to lock it.
For a SIM card:
• Slide the SIM card metal door latch to the right to unlock it, then flip the door open.
• Slide the card into the guides on the SIM card door.
• Swing the hinged door back down into place, and slide the metal door latch to the left to lock it.

Scanners and Imagers

IMPORTANT
NOTE
To enable a newly-installed imager or scanner, press and hold down the [FN]
key and the [Enter/Power] key simultaneously for a minimum of three
seconds.
If your unit has a [Power] button, press and hold down the [FN] key and the
[Power] button for a minimum of three seconds.
The Omnii supports a wide range of scanner options to address a variety of user application requirements.
Refer to the following sections for detailed information:
• Scanner list and specifications:
• Configuration:
• "Scanning Techniques" on page 2-16
It is critical that you review the "Laser Warnings" in the Omnii
Hand-Held Computer Regulatory & Warranty Guide (PN 8000191)
before using any of the scanners described in this chapter.
For detailed scanner specifications and decode zone tables, refer to
Appendix D: "Internal Imager & Scanner
Appendix D: "Internal Imager & Scanner
"Scanners" on page 3-55
outlines the mechanics of a successful scan.
Getting To Know Your Omnii 2 - 15
Specifications".
and "Manage Triggers" on page
Specifications".
3-40.