Panasonic AG-CPD20P Operating Instructions Manual page 22

Setup
(continued)
Setting Item
 Rec Continue Time
PreRec Time
(Video)
PreRec Time
(Audio)
PostRec Time
(Video)
PostRec Time
(Audio)
Rule of
Filename
Init Audio Rec
Init Overlay OSD
GPO1 Signal
GPO Signal
GPO Signal
Init Audio Out
(Play)
Play Mode
Skip Target
Trigger/Marker
Head of File
* 1 If "Loop Rec" is set to ON, pre-recording and post-
recording do not function.
*  Applies the setting in effect when power was last turned
off. Unless power is turned off properly, the operating
state may not be saved correctly.
 The functions of GPO1, GPO, and GPO can be
*
changed with settings, but GPO4 always outputs the
power status of the recorder, and has no setting.
Factory Default Value
Continuous recording time (minutes)
CONTINUE
Video Prerecord time (seconds)
0 s
Audio Prerecord time (seconds)
0 s
Video Postrecord time (seconds)
0 s
Audio Postrecord time (seconds)
0 s
Recording file naming method
WT
Initial on/off setting for Audio input (upon power on)
ON
Initial OSD (on-screen display) overlay setting
OFF
OFF GPO1 output signal setting
OFF GPO output signal setting
OFF GP  output signal setting
ON Initial audio output selection (upon power on)
SINGLE Select playback mode (relay playback setup)
Skip position
Select a trigger or marker location
YES
Select the starting point of the file
YES
Description
Setting : CONTINUE, 1 min,  min, 5 min, 10 min, 15 min, 0 min,
0 min, 60 min, 90 min
Setting : 0 s, 10 s, 0 s, 0 s, 60 s, 90 s
Setting : 0 s,  s, 10 s, 0 s, 0 s, 60 s, 90 s
Setting : 0 s, 10 s, 0 s, 0 s, 60 s, 90 s
Setting : 0 s,  s, 10 s, 0 s, 0 s, 60 s, 90 s
Setting : WT(World time)
LT(Local time)
*
Setting : ON, LAST , OFF
1
Setting : OFF, AUTO, SIMPLE, DETAILS, LAST
*
Setting: OFF, REC, ERROR, REC+ERROR
*
Setting: OFF, REC, ERROR, REC+ERROR
*

Setting: OFF, REC
*
Setting : ON, LAST , OFF

Setting : SINGLE, RELAY
Setting : YES, NO
Setting : YES, NO
Playback with the remote control panel is not available
at present. Upgrading is scheduled for the future.
For playback, it is recommended to use the Front-End
application or Back-End Client application.

*
1
*
1
*
1
*
1
*



(Continued on the next page)