Panasonic AG-CPD20P Operating Instructions Manual page 26

Setup
(continued)
Setting Item
7 Camera1
Zoom Limit
AGC Level
Init Backlight
Init AE Shift
Flip
AutoZoom
Magnification
AutoZoom Time
AutoZoom End Position
Init Camera1 Rec
LED
Init IR Mode
IR Level
IR Time
Auto Focus
Init LPR Mode
*
1 Applies the setting in effect when power was last turned
off. Unless power is turned off properly, the operating
state may not be saved correctly.
*
 When the [Init AE Shift] setting is "+" and the target is
dark, the image may not refresh at 0 frames/sec.
*
 The [IR Level] and [IR Time] settings apply only when the
[Init IR Mode] setting is "AUTO".
Factory Default Value
×0
HIGH
OFF
0
OFF
×10
 s
×1
ON
AUTO
LOW
0 s
PRESET
DISABLE
Color Camera connected to the [CAMERA 1] connector setting
Maximum zoom magnification
Setting : ×, ×0
Color Camera automatic gain control setting
Setting : HIGH, OFF, LOW, MID
Initial backlighting compensation setting (upon power on)
Setting : ON, OFF, LAST
(perform backlighting compensation when on)
Initial exposure compensation of Color Camera video (upon power on)
Setting :0, +1, +, LAST
Color Camera image top/bottom flip enable/disable
Setting : OFF (Top/bottom flip disabled)
ON (Top/bottom flip enabled)
Magnification of auto zoom
Setting : ×10, ×15, ×, ×1, ×, ×, ×4, ×5, ×7
Auto zoom magnification retention time (seconds)
Setting :  s, 5 s, 8 s
Target magnification of auto zoom
Setting: ×1, ×, ×, ..., ×, LAST
Initial Color Camera [REC] lamp enable/disable setting (upon power
on)
Setting : ON ([REC] lamp lights during recording)
*
LAST
1
OFF ([REC] lamp does not light)
IR switching function
Setting : AUTO (Automatically switch IR function on/off),
OFF (Force IR function off)
ON (Force IR function on)
*
LAST
1
IR auto switching level setting
Setting : LOW, HIGH
IR auto switching level detection time (seconds)
Setting : 0 s, 60 s, 00 s, 10 s
Select color camera focusing method when,
• [Init LPR Mode] is set to "DISABLE"
• [Init LPR Mode] is set to "ENABLE" and [LPR Mode] is set to
"PATROL"
• A recording trigger starts recording when [Init LPR Mode] is set to
"ENABLE" and [LPR Mode] is set to "LPR".
Setting :
PRESET (When the zoom is x or below, the camera is
focused at a distance of about 15 m (50 feet).
Subsequent zooming will engage auto focus.)
DISABLE (Focus is locked at a distance of about 40 m (10
feet) and auto focus is disabled.)
AUTO (Set to auto focus when zoom ratio has been
changed.)
LPR (License Plate Recognition) function switching
Setting :
DISABLE (LPR function is off and [LPR Mode] switches to
"PATROL".)
ENABLE (LPR function is on.)
6
Description
*
1
*
, -, -1
1
*
1
*

*

(Continued on the next page)
*