NEC Univerge SV8100 Installation Manual page 16

The general page needs to be imported to tell MyCalls the IP Address of the PBX and the TCP ports
used. The general page will also verify that the SMDR is configured correctly on the SV8100. There
are 3 different pages from where the general page can be taken from depending on the SV8100
configuration. The rules on which general page you should use can be determined as follows:
•
If you are going to collect the P commands and SMDR from the Ethernet port of the CCPU
then use the General (CCPU) page. This page is normally used where the VOIP is not being
used on the PBX.
•
If you are using the IPLA for the SMDR and P command Output then you should use the
General (IPLA) Page.
•
If you are using Netlink then you should always use the General (Netlink.) This means that
the SMDR and P Commands will be collected from the IPLA card.
When you have selected the correct general page, select the entire contents of the page and press
Ctrl + C or right click and select Copy Selection. Now switch to the Configuration Import Tool, right
click and choose to Paste General Information.
Once you have the items you require in the Configuration Import Tool click the import icon.