NEC Univerge SV8100 Installation Manual page 76

If trunk 1 on the PBX is connected to the first port of the recorder, click the Assign button to
configure the Channel Mapping.
When you have clicked the Assign button, use the drop down menus to assign trunk 1, unit ID 1, Port
1 and Channel 0.
Repeat this procedure for trunk 2, setting all the items the same except that the Channel Number will
be 1.
This will need to be carried out for each trunk that is recorded, refer to the below table which shows a
typical configuration where trunks 1-8 are recorded.
Trunk
1
2
3
4
5
6
7
8
Once each trunk has been configured, click OK to save the changes to the recorder configuration,
then click OK to save the new PBX configuration.
Once these changes have been made, it is recommended that you make a call on each trunk that has
been configured to confirm that the Channel Mapping is working correctly.
Unit ID
1
1
1
1
1
1
1
1
Port
1
1
3
3
5
5
7
7
Channel
0
1
0
1
0
1
0
1