Table of Contents
Advertisement
Troubleshooting
Check
Is WirelessHD set to Off?
Are signals being received within the Wire‐
lessHD transmission range?
Is the supplied WirelessHD Transmitter
turned on?
Is the WirelessHD indicator for the supplied
WirelessHD Transmitter off?
Is the Link indicator for the supplied Wire‐
lessHD Transmitter off?
Has dust collected in the WirelessHD Trans‐
mitter's vent?
Are the projector and the WirelessHD Trans‐
mitter facing the correct way?
Is "Source: WirelessHD X"/"No Signal" dis‐
played in the lower-left part of the screen?
WirelessHD audio is not output correctly.
Check
Is audio output when the WirelessHD is con‐
nected?
Interference, distortion, or interruption appear in WirelessHD
Check
Are signals being received within the Wire‐
lessHD transmission range?
When WirelessHD is set to Off from the Configuration menu,
projection is not possible for WirelessHD input signals. Set Wire‐
lessHD to On, and then press the
WirelessHD
p.79
Check the range within which the WirelessHD's transceiver can
communicate, and view within that range.
Check the power lamp on the WirelessHD Transmitter. If there is
no power being supplied, make sure the connector for the AC
adapter is securely connected, and then turn on the power
switch.
No signal is output from the AV device connected to the Wire‐
lessHD Transmitter. Check that the cables from the AV device and
the WirelessHD Transmitter are securely connected.
When you last viewed the images that had been output to a
monitor device, such as television, via the Output port, the im‐
ages will be projected on the same monitor device as the last one
the next time the projector is turned on. To cancel the setting,
press the
button (switch output) on the remote control
while pointing it at the WirelessHD Transmitter.
The WirelessHD cannot communicate with the projector. Check
the range within which the WirelessHD's transceiver can com‐
municate, and setup within that range.
Has dust collected in the WirelessHD Transmitter's vent? Com‐
munication may not be possible if dust has collected in the vent.
Install the projector so that dust does not collect in the vent.
Setup the projector and the WirelessHD Transmitter so that they
are facing each other.
Check that the AV device connected with the HDMI port on the
WirelessHD Transmitter is turned on. The input signal number
displayed on the screen is the same as the HDMI port number.
In addition, unless HDMI Link is set to On, the connected device
does not turn on. Set HDMI Link to On.
Link - HDMI Link
p.79
When connecting a device, such as a sound bar, to the Optical
Audio-Out port on the WirelessHD Transmitter to output audio
from there, set Audio Out Device to WirelessHD Transmitter.
The connected sound bar must be set to surround sound. To
output audio from the projector, set it to Projector.
tings - HDMI Link - Audio Out Device
Check the range within which the WirelessHD's transceiver can
communicate, and view within that range.
99
Remedy
button.
s
p.61
s
s
Settings - HDMI
s
Remedy
p.79
Remedy
p.61
s
Settings -
p.63
Set‐
s
Advertisement
Table of Contents
