Adjusting the Image
Viewing the Image at the Saved Image Quality
(Memory Function)
Saving Function
You can save the adjustment values for some images and image quality settings in the Configuration menu
for later use (Save Memory).
Because these saved adjustment values can be loaded from the remote control, you can easily switch to your
preferred image quality (Load Memory).
The following Configuration menu functions can be saved.
Color Mode, Brightness, Contrast, Color Saturation, Tint, Skin Tone, Sharpness, Color Temp..,
Image
Power Consumption, Auto Iris
p.75
s
Advanced
Signal
Deinterlacing, Motion Detection, Super-resolution
p.77
s
Advanced
Saving a Memory
You can register a memory when Color Mode is set to anything except Auto.
a
Make settings that you want to save to
the Configuration menu.
b
Press the
c
Use the
select Save Memory, and then press
the
button to confirm the
selection.
The Save Memory screen is displayed.
Gamma, Offset, Gain, Hue, Saturation, Brightness, EPSON Super White
Noise Reduction, Setup Level, Overscan, HDMI Video Range
button.
buttons to
d
Use the
select the memory name to be saved,
and then press the
confirm the selection.
The current projector settings are saved to
the memory.
If the mark on the left of the memory name
is turned aqua, it means the memory has
already been registered. When you select a
registered memory, a message is displayed
asking you to confirm that you want to
overwrite the memory. If you select Yes, the
previous content is erased and the current
settings are saved.
43
buttons to
button to