Table of Contents
Advertisement
Useful Functions
d
If projection does not start, press the
source.
Make sure you point the remote control at the projector when using the
control.
Projection starts.
e
When connecting two or more AV devices to the WirelessHD Transmitter, press the
button to switch images.
c
•
When receiving WirelessHD images, make sure WirelessHD is set to On from the Configuration menu.
Settings - WirelessHD - WirelessHD
s
•
Make sure you turn off the WirelessHD Transmitter if it is not going to be used for an extended period.
WirelessHD Settings Menu
a
Press the
The Configuration menu is displayed.
b
Select Settings - WirelessHD, and
then press the
the selection.
The WirelessHD settings screen is
displayed.
Available functions on the WirelessHD settings menu
Function
Device Connections
WirelessHD
Video Reception
WiHD Mode
p.65
s
button.
button to confirm
Displays a list of available WirelessHD devices that can be connected. The device names
and MAC addresses (device numbers) are displayed in the list. The MAC address is
displayed on the label on the base.
Enables or disables the WirelessHD function.
Displays the reception for the image being projected.
Use Full for most situations. Full mode uses the maximum video bandwidth at all times.
Dynamic mode extends wireless ranges while optimally adjusting video bandwidth.
Set to Dynamic if the image is interrupted due to weak signals and other causes.
button on the remote control to change the
p.79
c
Make settings for each of the
displayed functions.
Explanation
60
button on the remote
Advertisement
Table of Contents
