Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual page 112

NOTE
l
This vehicle is equipped with ignition switch
illumination.
• The ignition switch illumination comes
on while the driver's door is opened and
remains on for about 30 seconds after the
driver's door is closed.
• [On vehicles with keyless entry system]
When you get out of the vehicle and re-
move the ignition key, it will be illumina-
ted for about 30 seconds.
However, it will go off even while the il-
lumination comes on if the ignition
switch is set to "ON" position.
l For vehicles equipped with the Daytime Run-
ning Lamp, when the ignition switch is in the
"ON" position, the headlamp low beams etc.
are turned on.
Refer to "Headlamps" on page 3-18.
l Your vehicle is equipped with an electronic
immobilizer. To start the engine, the ID code
which the transponder inside the key sends
must match the one registered in the immobil-
izer computer. (Refer to "Electronic immobil-
izer (Anti-theft starting system)" on page
1-03.)
To remove the key
For vehicles with M/T, when removing the key,
push in the key at the "ACC" position and keep it
depressed until it is turned to the "LOCK" position,
then remove the key.
M/T
For vehicles with A/T, when removing the key,
first set the selector lever to the "P" (PARK) posi-
tion, and then turn the key to the "LOCK" position,
then remove the key.
A/T
Starting and driving
CAUTION
l
If the engine is stopped while driving, the
brake servomechanism will cease to func-
tion and braking efficiency will deterio-
rate. Also, the power steering system will
not function and it will require greater
manual effort to operate the steering.
l Do not leave the key in the "ON" position
for a long time when the engine is not run-
ning, doing so will cause the battery to be
discharged.
l Do not turn the key to the "START" posi-
tion when the engine is running, doing so
could damage the starter motor.
4
4-09