Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual page 238

2. Depress the tab (C) on the harness connector
and pull the harness connector (D) to remove
it.
3. Remove the entire socket and bulb assembly
(E) by turning it anticlockwise.
4. To install the bulb, perform the removal
steps in reverse.
CAUTION
l
Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the
bulb to break the next time the fog lamps
are operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly.
Rear combination lamps
E01004201063
1. Insert a straight blade (or minus) screwdriver
with a cloth over its tip into the notch at the
Maintenance
bottom of the lid of the lamp whose bulb you
wish to replace. Use it to lever off the lid.
2. Turn the socket anticlockwise and remove it.
Withdraw the bulb from the socket.
A- Rear turn-signal lamp
B- Rear fog lamp (driver's side)
Reversing lamp (passenger's side)
3. To install the bulb, perform the removal
steps in reverse.
8
8-29