Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual page 146

NOTE
l
When the mode selection dial or the blower
speed selection dial is set to the "AUTO" po-
sition again after manual operation, the air se-
lection switch will also be automatically con-
trolled.
Air conditioning switch
E00703500785
Push the switch, and the air conditioning compres-
sor will turn on. The air conditioning indication
lamp (A) will come on.
Push the switch again and the air conditioning com-
pressor will stop and the indication lamp (A) goes
off.
CAUTION
l
When using the air conditioning, the
idling speed may slightly increase as the
air conditioning compressor is switched
on/off automatically. While the vehicle
with an A/T is stationary, fully depress
the brake pedal to prevent the vehicle
from creeping.
NOTE
l If a problem is detected in the air condition-
ing system, the air conditioning operation in-
dication lamp (A) blinks. Press the air condi-
tioning switch once to turn it off, then once
more to turn it back on. If the air condition-
ing operation indication lamp (A) does not
blink for a while, there is nothing wrong. If it
starts to blink again, we recommend you to
have it checked.
l Sometimes, for example after using a high-
pressure car wash, the condenser can get wet,
and the operation indication lamp (A) blinks
temporarily. In this case there is nothing
wrong. Wait a while, press the air condition-
ing switch once to turn the system off, then
once more to turn it back on. Once the water
evaporates, the blinking will stop.
For pleasant driving
Operating the system in automatic
mode
E00704100557
In normal conditions, use the system in the AUTO
mode and follow these procedures:
1. Set the blower speed selection dial to the "AU-
TO" position.
2. Select the temperature control dial to the de-
sired temperature. The temperature can be
set within a range of 15 to 29. The tempera-
ture will gradually increase as the dial is
turned to the right.
3. Set the mode selection dial to the "AUTO"
position.
4. Push the air conditioning switch to operate
the air conditioning. When the air condition-
ing operates, the indication lamp (
dial will come on.
The outlet port (except " "), recirculation/out-
side air select and blower speed, and ON/OFF of
air conditioning will be controlled automatically.
To stop the system, turn the blower speed selection
dial to the "OFF" position.
5
) in the
5-07