Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual page 145

For pleasant driving
NOTE
l
While the engine coolant temperature is low,
the temperature of the air from the heater
will be cool/cold until the engine warms up,
even if you have selected warm air with the
dial.
l When the temperature is set to the highest or
the lowest, the air selection and the air condi-
tioning will be automatically changed as fol-
lows.
Also, if manually operated after an automatic
changeover, manual operation will be selec-
ted.
• Quick Heating (When the temperature is
set to the highest setting)
Outside air will be introduced and the air
conditioning will stop.
• Quick Cooling (When the temperature is
set to the lowest setting)
Inside air will be recirculated and the air
conditioning will operate.
5
5-06
Mode selection dial
E00703200418
To change the position and amount of air flowing
from the ventilators, turn the mode selection dial.
(Refer to "Changing the front mode selection" on
page 5-03.)
CAUTION
l
When using the mode selection dial be-
tween the " " and " " positions, pre-
vent fogging by pressing the air selection
switch to select outside air.
(Refer to "Air selection switch" on page
5-06.)
Air selection switch
E00703400511
To change the air selection, simply press the air se-
lection switch.
l Outside air {Indication lamp (A) is OFF}
Outside air is introduced into the passenger
compartment.
l Recirculated air {Indication lamp (A) is ON}
Air is recirculated inside the passenger com-
partment.
CAUTION
l Normally, use the outside position to keep
the windscreen and side windows clear
and quickly remove fog or frost from the
windscreen.
If high cooling performance is desired, or
if the outside air is dusty or otherwise con-
taminated use the recirculation position.
Switch to the outside position periodically
to increase ventilation so that the win-
dows do not become fogged up.
l Use of the recirculation position for exten-
ded time may cause the windows to fog up.