Procedure To Install Windows In San/Iscsi Storage Device; Presetting - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 4 Installation of Operating System and bundled software

4.3 Procedure to install Windows in SAN/iSCSI storage device

Example)
In case of RHEL6
- Comment out the line of splashimage = (hd0, 1) / grub / splash.xpm.gz in /etc/grub.conf
- Added "console = ttyS0, 19200n8" in the kernel line of /etc/grub.conf" in /etc/grub.conf
In case of RHEL7
1. Change setting file
Add "console = ttyS0, 115200" in the GRUB_CMDLINE_LINUX of /etc/default/grub
2. Reflect changes
- In case of UEFI boot
- In case of Legacy boot
- When the OS starts "Fast TSC calibration failed" appears in RHEL message.
This message is output when access performance to the PIT (Programmable Interval Timer) is less than the
expected value in TSC (Time Stamp Counter) adjustment process of OS boot. This cause is virtualization overhead of
PIT, which is performed by the Extended Partitioning Firmware. But in this case, the system does not be affected
because the OS switches automatically to the HPET (High Precision Event Timer).
4.3 Procedure to install Windows in SAN/iSCSI storage device
Here, the procedure to install Windows in SAN storage device is explained. Start the installation after confirming the MMB
configuration setting and successful login to the MMB.

4.3.1 Presetting

The following settings are done if necessary.
1. LUN of SAN storage device is set.
2. [PCI ROM Priority] of BIOS is set.
- For the UEFI Install
- Set [Device Manager]-[PCI Subsystem Configuration]-[PCI ROM Priority] of BIOS menu to "EFI Compatible
ROM".
- For the Legacy Install:
- Set [Device Manager]-[PCI Subsystem Configuration]-[PCI ROM Priority] of BIOS menu to "Legacy ROM".
- Set [Device Manager]-[PCI Subsystem Configuration]-[OpROM Scan Configuration] of BIOS menu to "Enable"
only for booting Device.
3. BIOS is set to recognize LUN of FC card.
For the settings of FC card,
SAN Boot Environment Configuration Manual .
4. The partition settings in MMB are confirmed after the internal HDD/SDD of PRIMEQUEST is removed.
- SB/IOU configuration is set
See "3.4.1 Setting the partition
- Console redirection is set
See "3.4.6 Settings of Console
- Video redirection: Enable
- Virtual media: Enable
- Various modes are set
See "3.4.5 Various mode
5. Only LUN which becomes the installation target of SAN storage device is connected to the partition of
PRIMEQUEST.
For the settings of SAN storage device, see "Attached manual in the SAN storage device".
6. I/O space is allocated in PCI Cards.. For the allocation of I/O space, see
document and "3.4.4.2 I/O Space Assignment Configuration" of PRIMEQUEST 2000 series Tool Reference
(CA92344-0539).
- Execute "grub2-mkconfig -o /boot/efi/EFI/redhat/grub.cfg" command.
- Execute "grub2-mkconfig -o /boot/grub2/grub.cfg" command.
Converged Network Adapter and NIC for iSCSI
configuration"
Redirection"
settings"
Boot, see PRIMEQUEST 2000 Series
61
"3.4.5 Various mode settings" in this
CA92344-0536-04