Chassis Cover Removal And Replacement - NEC Generation N3000 M760s User Manual

To store or carry any component, place it in an anti-static bag.
Turn off and disconnect all peripherals.
Do not disassemble parts other than those specified in the procedure.
Label any cable connectors before disconnecting. Note where the connector goes and in what
position it was installed.
Take care when connecting or disconnecting cables. A damaged cable can cause a short in the
electrical circuit.
When installing a cable, route the cable so it is not pinched by other components and is out of the
path of the system unit cover.
Prevent damage to the connectors by aligning connector pins before you connect the cable.
Misaligned connector pins can cause damage to system components at power-on.
When disconnecting a cable, always pull on the cable connector or strain-relief loop, not on the
cable itself.

Chassis Cover Removal and Replacement

When working inside your computer, you must replace the chassis cover and secure it with the screws
before plugging in the power cable and turning it on.
© 2007-2009, NEC Computers S.A.S. All rights reserved.
Preface
15