Hitachi 3080 G2 Hardware Reference Manual page 112

• 192.0.2.2/24 eth1 (testhost private IP)
• 192.168.4.120/24 eth0 (testhost external IP, which might vary)
On the replacement server:
Procedure
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
112
Log in to the server.
Run the nas-preconfig script.
The IP addresses are assigned at this step.
Reboot if you are instructed to by the script.
Log in to the SMU using one of the IP addresses you obtained once they
can successfully connect using ssc localhost.
Use a KVM (keyboard, video, and mouse) or a serial cable to connect to
the serial port on the server.
Alternatively, you can connect by way of SSH using the following
settings:
• 115,200 b/s
• 8 data bits
• 1 stop bit
• No parity
• No flow control
• VT100 emulation
Log in as root (default password: nasadmin), and enter ssc localhost
to access the BALI level.
Enter evs list to see the IP configuration for the server.
Using a supported browser, launch the Web Manager (SMU GUI) using
either of the IP addresses acquired from the EVS list output.
Click Yes to proceed past the Security Alert, and log in as admin (default
password: nasadmin).
Verify and, if necessary, convert the new server to the model profile
required.
This step requires a separate process, training and equipment. Contact
support if the incorrect model arrives for replacement.
Navigate to Home > Server Settings > Firmware Package
Management to verify and, if necessary, upgrade the new server to the
latest SU release.
Navigate to Home > Server Settings > IP Addresses, and change the
node IP address acquired from the old server.
If necessary, change the default private IP address (192.0.2.2) if it
conflicts with an existing IP address in the cluster configuration.
Reconnect the data cables to the server, including the intercluster and
private management network cables.
Server replacement procedures
Hitachi NAS Platform 3080/3090 G2 Hardware Reference Guide