Reception - Silvercrest SSR 576 A1 User Manual And Service Information

Digital SD Sat Receiver SSR 576 A1
English - 22

Reception

To successfully launch a channel search, you
need to adjust your satellite receiver to the
installed antenna. If you want to receive one
satellite only, under "Equipment Control" select
"Off". If you want to receive more than one
satellite, you can use the "DiSEqC easy"
function to enable DiSEqC 1.0 antenna motor
control. DiSEqC allows channels to be received
from multiple satellites in different orbit positions.
For instance, instead of using two LNBs pointing
to two different satellites (e.g. Astra and
Hotbird), you can use a DiSEqC LNB and a
DiSEqC switch. For instance, choose "Astra 1"
for satellite A and "Hotbird" for satellite B. Press
the - (29) and + (41) buttons to select the
desired satellites. Press the OK button (40) to
show a satellite list. Only the satellites activated
via Edit Settings | Satellite Systems (see the
following chapter) will appear here.
Note: Some DiSEqC switches are labelled using
numbers (1, 2, 3, 4 etc.) instead of letters.
However, the order is identical.
When using a motor-driven antenna system,
please also read the User's Manual for your
antenna motor. Under "Equipment Control"
select the corresponding antenna motor control.
You can use the "Program motor positions" and
"Location configuration" submenus to adjust
further motor-driven antenna settings.
When using a single cable device (SCD) you
can configure the corresponding setting under
"SCD configuration". Please also refer to the
User's Manual of your antenna system.
We cannot provide any further descriptions at
this stage, as the individual settings for each
motor-driven antenna and SCD are very specific.
When configuring your system, please also read
the notes displayed on the OSD menu.