Ignition Switch Removal And Installation; Ignition Switch Inspection; Combination Meter Removal And Installation - Suzuki SX4 Service Manual

Ignition Switch Removal and Installation

Removal
1) Disconnect negative cable at battery.
2) Confirm that ignition key is removed.
3) Remove dash side trim (4) and steering column hole
cover (1).
4) Turn steering wheel to remove steering column
cover screws (3) and then remove steering column
covers (2).
2
4
5) Remove steering column mounting nuts referring to
Step 7) under "Removal" of "Steering Column
Removal and Installation in Section 6B".
6) Disconnect couplers (1) from ignition switch (2).
7) Remove ignition switch (2) from key cylinder (3).
2
1
Installation
Reverse removal procedure noting the following.
Tighten steering column mounting nuts referring to Step
2) under "Installation" of "Steering Column Removal and
Installation in Section 6B".

Ignition Switch Inspection

• Check for continuity between terminals at each switch
position. If check result is not as specified, replace
switch.
Repair Instructions
S7RW0A9306001
3
1
I7RW01930006-01
1
I4RS0A930008-01
S7RW0A9306002
Instrumentation / Driver Info. / Horn:
ST
B2
IG1 ACC
Terminal
Key Position
OUT
LOCK
ACC
IN
ON
START
Ignition knob switch
(with keyless start system only)
OFF (ignition knob switch released)
ON (ignition knob switch pushsed)

Combination Meter Removal and Installation

Removal
3
1) Disconnect negative (–) cable at battery.
2) Remove dash side trim (1) and steering column hole
cover (2).
P2
IG2
P1
B1
B1 B2 ACC IG1 IG2
Terminal
2
1
9C-15
K2
K1
ST K1 K2
P1 P2
I5RS0D930003-02
S7RW0A9306003
I7RW01930007-01