Trunk Lid Lock Assembly Removal And Installation (Sedan Model) - Suzuki SX4 Service Manual

9F-14 Security and Locks:
Trunk Lid Lock Assembly Removal and
Installation (Sedan Model)
Removal
1) Remove trunk lid trim (1) from trunk lid panel (if
equipped).
2) Disconnect trunk lid latch control rod (1) from trunk
lid.
3) (Keyless start model)
Disconnect trunk lid latch actuator coupler (3).
4) (Keyless start model)
Remove trunk lid latch actuator (2) from trunk lid.
1
5) (Non- keyless start model)
Remove trunk lid lock cylinder (1) from trunk lid.
6) Remove trunk lid latch bolt (1), and then disconnect
trunk lid opener wire (2) from trunk lid latch (4).
S7RW0A9606021
7) Remove trunk lid latch (4) with trunk lid latch control
rod (3).
1
I6RW0B960006-01
Installation
Reverse removal procedure to install trunk lid lock
assembly noting the following instruction.
• Tighten trunk lid latch bolt (1) to specified torque.
Tightening torque
Trunk lid latch bolt (a): 4.5 N·m (0.45 kgf-m, 3.5 lb-
ft)
3
2
I8RW01960003-01
• Adjust trunk lid latch striker (1) so that its center aligns
with the center of groove in trunk lid latch base (2).
Tightening torque
Trunk lid latch striker bolt (a): 4.5 N·m (0.45 kgf-
m, 3.5 lb-ft)
1
I8RW01960004-01
3
2
4
1
1,(a)
2
1,(a)
I6RW0B960005-01
I6RW0B960008-01
I6RW0B960011-01