Front Fender Components; Front Fender Removal And Installation - Suzuki SX4 Service Manual

9J-2 Hood / Fenders / Doors:

Front Fender Components

1. Front fender lining

Front Fender Removal and Installation

Removal
1) Remove side sill splash guard and front fender splash guard (if equipped) referring to "Splash Guard Removal and
Installation (If Equipped) in Section 9M".
2) Remove front fender lining.
3) Remove front bumper referring to "Front Bumper and Rear Bumper Components in Section 9K".
4) Remove headlight assembly referring to "Headlight Housing Removal and Installation in Section 9B".
5) Disconnect connector from side turn signal light (if equipped).
6) Remove front fender cover.
7) Remove front fender.
Installation
Reverse removal procedure to install front fender noting the following instruction.
• If paint on fender bolt is peeled off, be sure to apply paint again.
• Adjust panel clearance referring to "Panel Clearance in Section 9K".
3
1
2. Front fender
S7RW0A9A06003
2
I5RW0A9A0004-01
3. Front fender cover
S7RW0A9A06004