Horn Relay Inspection; Antenna Base Removal And Installation (Hatchback); Remote Audio Control Switch Removal And Installation (If Equipped) - Suzuki SX4 Service Manual

9C-22 Instrumentation / Driver Info. / Horn:

Horn Relay Inspection

1) Disconnect negative (–) cable at battery.
2) Remove junction block.
3) Remove horn relay (1) from junction block (2).
4) Check that there is no continuity between terminals
"c" and "d". If there is continuity, replace relay.
5) Check that there is continuity between terminals "c"
and "d" when a 12 V battery is connected to
terminals "a" and "b". If malfunction is found, replace
it with a new one.
b a
c
d
Antenna Base Removal and Installation
(Hatchback)
Removal
1) Remove head lining referring to "Head Lining
Removal and Installation in Section 9H".
2) Remove antenna (1) from antenna base (2).
3) Disconnect antenna feeder from antenna base (2).
4) Remove antenna base (2) from vehicle.
Installation
Reverse removal procedure noting the following.
• Tighten antenna base mounting bolt to specified
torque.
Tightening torque
Antenna base mounting bolt (a): 5.0 N·m (0.5 kgf-
m, 4.0 lb-ft)
• Install head lining referring to "Head Lining Removal
and Installation in Section 9H".
S7RW0A9306023
1
2
I4RS0B930018-01
c
d
a
b
I3JA01920006-01
S7RW0A9306024
1
2
(a)
I7RW01930012-01
Remote Audio Control Switch Removal and
Installation (If Equipped)
Remove
1) Remove steering wheel referring to "Steering Wheel
Removal and Installation in Section 6B".
2) Remove steering wheel cover (1) from steering
wheel.
2
2. Screw
3) Remove remote audio control switch (1) from
steering wheel.
2. Screw
Installation
Reverse removal procedure noting the following.
• Install steering wheel referring to "Steering Wheel
Removal and Installation in Section 6B".
S7RW0A9306025
1
I5RW0A930025-02
1
2
I5RW0A930026-02