Suzuki SX4 Service Manual page 1480

9E-8 Glass / Windows / Mirrors:
4) Clean contact surfaces of old adhesive (4), paint or
bare metal thoroughly.
If surfaces of paint or bare metal come out, apply
primer (2) for body with caution not to apply primer
(2) to surface of adhesive remaining on body.
NOTE
• Be sure to refer to primer maker's
instruction for proper handling and drying
time.
• Do not touch body and old adhesive
surfaces where glass is to be adhered.
1. Do not apply primer
5) Install new molding to glass.
6) Clean glass surface to be adhered to body with
clean cloth. If cleaning solvent is used, let it dry for
10 minutes or more.
Cleaning Area for windshield (distance from the
edge of glass or molding)
30 – 50 mm (1.19 – 1.96 in.)
7) Install new spacers (1) to windshield (2).
I2RH01950046-01
3. Apply primer
2
1
I5RW0A950004-01
8) Using new brush, apply sufficient amount of primer
onto glass along glass edge.
NOTE
• Be sure to refer to maker's instruction for
proper handling and drying time.
• Do not apply primer on outside of ceramic
coated surface.
• Do not touch primer coated surface.
Width applied primer for windshield
"a": 17 mm (0.67 in.)
"b": 20 mm (0.79 in.)
"a"
1
2
"b"
1. Molding
9) Apply primer for molding along molding surface all
around.
10) Apply adhesive (1) referring to figure.
NOTE
• Press glass (2) against fittings surface of
body panel quickly after adhesive (1) is
applied.
• Use of rubber sucker grip is helpful to hold
and carry glass after adhesive (1) is
applied.
• Perform steps 8) to 9) within 10 min. to
ensure sufficient adhesion.
• Be sure to refer to adhesive maker's
instruction for proper handling and drying
time.
• Start from bottom side of glass (2).
• Be careful not to damage primer.
"a"
1
I5RW0A950005-01
2. 40 mm (1.57 in.)