Rear Door Window Regulator Inspection; Rear End Door Window / Back Window Defogger Switch Inspection; Rear End Door Window / Back Window Defogger Relay Inspection - Suzuki SX4 Service Manual

Hide thumbs Also See for SX4:
Table of Contents

Advertisement

9E-20 Glass / Windows / Mirrors:
Installation
Reverse removal procedure noting the following.
• Apply grease to sliding and rotating portions of
window regulator.
: Grease 99000–25011 (SUZUKI Super Grease A)
• Tighten rear door window regulator attaching screws.
Rear door window regulator screw tightening
order
(1) → (2)

Rear Door Window Regulator Inspection

Check the following point:
• Check regulator sliding and rotating parts.
• Check rollers for wear and damage.
Rear End Door Window / Back Window
Defogger Switch Inspection
1) Check rear end door window/back window defogger
switch for operation as follows.
a) Rear end door window/back window defogger
switch is built in HVAC control module (unit).
Remove HVAC control module (unit) referring to
"HVAC Control Unit Removal and Installation in
Section 7A" or "HVAC Control Module Removal
and Installation: Automatic Type in Section 7B".
b) Check that there is continuity between terminal
(1) and terminal (2) of HVAC control module
(unit) when rear end door window/back window
defogger switch is at ON position. (Rear end
door window/back window defogger switch is
kept in push.)
c) Check that there is no continuity between
terminal (1) and terminal (2) of HVAC control
module (unit) when rear end door window/back
window defogger switch is at OFF position.
If check result does not meet the above
conditions, replace HVAC control module (unit).
2
1
2
I5RW0A950032-01
S7RW0A9506016
Rear End Door Window / Back Window
Defogger Relay Inspection
1) Disconnect negative (–) cable from battery.
2) Remove junction block assembly for inspection of
S7RW0A9506017
3) Remove rear end door window defogger relay (1)
[A]
1
2
[B]
1
[A]: Manual A/C model
rear end door window defogger relay.
For removal, refer to "BCM (Included in Junction
Block) Removal and Installation in Section 10B"
(Hatchback model).
(Hatchback) or back window defogger relay (4)
(Sedan) from junction block assembly (2).
4
3
2
3. Hood latch release cable
2
I5RW0A950033-01
[B]: Auto A/C model
S7RW0A9506018
2
1
I6RW0B950007-02

Advertisement

Table of Contents
loading

Table of Contents