Suzuki SX4 Service Manual page 1538

9J-10 Hood / Fenders / Doors:
Installation
Reverse removal procedure noting the following.
• Install torsion bars as following:
a. Open trunk lid and hold it.
b. Distinguish left side torsion bar (marking color:
yellow) from right side torsion bar (marking color:
blue) by marking color (1).
c. Apply grease to rotating part "A" of torsion bar.
"A": Grease 99000–25050 (SUZUKI Super
Grease E)
d. Install edge (2) of torsion bar to upward and fit end
(3) to groove of right side hinge bracket.
e. Install edge (2) of torsion bar to upward and fit end
(3) to groove of left side hinge bracket.
NOTE
Be sure to wipe off excess grease thoroughly
as it may stain trunk interior and luggage in
it.
"A"
2
1
I6RW0B9A0011-02
• Fore-and-aft and right-and-left adjustment. Adjust
trunk lid clearance by loosening trunk lid mounting
bolts (2).
• Adjust trunk lid latch striker (1) so that striker shaft
approximately aligns with the center of groove of trunk
lid latch.
1
• Tighten rear seat bolts referring to "Rear Seat
Components in Section 9G".
2
I6RW0B9A0012-01