Sdm Inspection; Driver Air Bag (Inflator) Module Removal And Installation - Suzuki SX4 Service Manual

8B-97 Air Bag System:
6) Install G sensor or yaw rate / G sensor referring to "G
Sensor Removal and Installation (4WD Model) in
Section 4E" or "Yaw Rate / G Sensor Removal and
Installation in Section 4F".
7) Install console box upper cover.
8) Enable air bag system referring to "Enabling Air Bag
System".
9) Connect negative (–) cable at battery.

SDM Inspection

WARNING
!
During service procedures, be very careful
when handling a Sensing and Diagnostic
Module (SDM).
Be sure to read "Precautions on Service and
Diagnosis of Air Bag System" before starting
to work and observe every precaution during
work. Neglecting them may result in personal
injury or inactivation of the air bag system
when necessary.
CAUTION
!
• Do not connect a tester whatever type it
may be.
• Never repair or disassemble SDM.
• If SDM has been dropped, it should be
replaced.
If any faulty condition is found in the following checks,
replace.
• Check SDM and SDM plate for dents, cracks or
deformation.
• Check SDM connector for damage, cracks or lock
mechanism.
• Check SDM terminal for bend, corrosion or rust.
Driver Air Bag (Inflator) Module Removal and
Installation
WARNING
!
When handling an air bag (inflator) module,
be sure to read "Precautions on Handling
and Storage of Air Bag System Components"
and observe each instruction. Failure to
follow them could cause a damage to the air
bag (inflator) module or result in personal
injury.
Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system. Refer to "Disabling Air Bag
System".
3) Loosen driver air bag (inflator) module mounting
bolts (1) till it turns freely, pull them out and fix them
to bolt clamps.
S7RW0A8206004
4) Remove air bag (inflator) module from steering
wheel.
5) Disconnect driver air bag (inflator) module connector
(1) of driver air bag (inflator) module and horn
connector (2) (if equipped) as shown in figure.
a) Unlock lock button (3).
b) With lock button unlocked, disconnect connector.
WARNING
!
Special care is necessary when handling and
storing a live (undeployed) air bag (inflator)
S7RW0A8206005
module. Observe "Precautions on Handling
and Storage of Air Bag System
Components". Otherwise, personal injury
may result.
1
b)
2
I3JA01820031-01
3
a)
I5RW0A820065-01