Mdc Configuration Example (In Standalone Mode) - HP 12500 Configuration Manual

Task
Display the interfaces of the MDC.
Display the CPU, disk space, and memory space
usage of the MDC in standalone mode.
Display the CPU, disk space, and memory space
usage of the MDC in IRF mode.

MDC configuration example (in standalone mode)

Network requirements
As shown in
Company A (LAN 1), Company B (LAN 2), and Company C (LAN 3).
The device has three interface cards, which reside in slot 2 to slot 4. Each card provides 48 Ethernet
interfaces.
Company A has four departments, each of which has large amounts of traffic and needs a dedicated link
to connect to the Internet gateway to achieve higher transmission speed. Company B and Company C
each need two links to connect to the Internet gateway, one of which for redundancy.
Company A has many users and requires more disk space than Company B and Company C. Company
B and Company C do not need a large amount of disk space and the default disk space is enough to
satisfy their disk space requirements.
Company C has less employees and less Internet traffic, and needs only a small amount of CPU
resources.
Figure 58 Network diagram
Configuration procedure
Create and configure MDCA for Company A:
1.
# Create MDCA.
Figure 58, use the device to satisfy the Internet access requirements of three companies:
Command
display mdc interface
display mdc resource [ cpu | disk | memory ] [ slot
slot-number ]
display mdc resource [ cpu | disk | memory ] [ chassis
chassis-number slot slot-number ]
204