APP-30: Feedback Freq. / Percentage Display
APP? Fbk/PER
30
[Hz]/[%]
Factory Default:
-
This code displays the feedback value using on PID
controller in Hz or %.
APP-31: Actual Value Display in Percentage
APP? Prs
31
[Bar]/[Pa]
Factory Default:
-
This code displays the value using on PID controller in
percentage.
APP-32: Pressure Display Scale
APP? Scale Disp
32
1000
Factory Def a ult:
1000
This parameter adjusts APP-31.
APP-33: Draw Mode Selection
APP? Draw Mode
33
None
Factory Default:
None
This code sets the signal input to use for Draw operation.
The main reference frequency is set in DRV-04. This
parameter should be set to a signal that is not selected
in DRV-04.
APP-34: Draw Size Setting
APP? Draw Perc
34
100 %
Factory Default:
100%
This code sets the frequency bandwidth during Draw
Morek IT OÜ, Rauna 24, 76506 Saue Harjumaa, Estonia. www.morek.eu Tel. +372 604 1423 Fax +372 604 1447 morek@morek.eu
30
0.00
0.00
31
0
0
32
1000
1000
33
0
0
34
100
100
151
Chapter 6 - Parameter Description [APP]
operation. For example, when Reference Frequency
(DRV-00) is set to ' 30Hz' , Draw Mode (APP-33) to
' V1_Draw' and Draw Size (APP-33) to ' 10%' , the
frequency difference during Draw operation is between
27 Hz and 33Hz. The following figure shows the block
diagram for Draw and Override operation.