Toshiba VF-S15 Instruction Manual page 66

3.2.2
[Example of fmod setting procedure] fmod=1: Setting the frequency by the terminal VIA
Panel operation
* Pressing the MODE key twice returns the display to standard monitor mode (displaying output frequency).
(1) Setting using the keypad (including extension panel option) (fmod=0 or 3)
 Example of operating from the panel (=: press in center to save)
Panel operation
 Example of operating from the panel (=: save even if power is off)
Panel operation
(2) Setting of frequency using external signals to terminal block (=, or )
 Refer to section 7.3 for details.
(3) Switching two frequency commands  Refer to section 5.8 for details.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
How to set the frequency
LED display
00
MODE
auh
fmod
0
1
1fmod
: Moves the frequency up
LED display



LED display



-
Displays the output frequency (operation stopped).
(When standard monitor display selection f710=0 [output frequency])
Displays the first basic parameter [History (auh)].
Turn the setting dial, and select "fmod".
Press the center of the setting dial to read the parameter value.
(Standard default: 0).
Turn the setting dial to change the parameter value to  (terminal block
VIA).
The parameter value is written. fmod and the parameter value are
displayed alternately several times.
: Moves the frequency down
Displays the output frequency.
(When standard monitor display selection = [output frequency])
Set the output frequency. (The frequency will not be saved if the
power is turned off in this state.)
Save the output frequency.  and the frequency are displayed
alternately.
Display the output frequency.
(When standard monitor display selection is set as =
[output frequency])
Set the output frequency.
The frequency will be saved when the power is turned off in this
state.
C-7
Operation
Operation
Operation
E6581611
3