Beko METPOINT OCV Installation And Operation Manual page 33

Connection of the measuring cell with the evaluation unit (step 20)
Protection against damage through electrostatic charging
The device contains electronic components which may be sensitive to electrostatic discharge (ESD). The contact with
electrostatically-charged persons or objects compromises these components. In the worst case, they are immediately
destroyed or will fail subsequent to the start-up.
Observe the requirements stipulated in EN 100015-1 to minimise or prevent the possibility of damage through sudden
electrostatic discharge. Please also make sure not to touch the electronic components while supply voltage is applied.
METPOINT ® OCV
Installation
20. Connect
evaluation unit with
sensor unit using
supplied signalling cable (10).
The ferrite must
connected on the side of the
evaluation unit.
Please make sure prior to
connecting the signalling cable
that both units are disconnected
from the power supply.
the
the
the
be
33