Reading Out Of The Measured Values Via The Ethernet Connection - Beko METPOINT OCV Installation And Operation Manual

NOTE!
Please also check the settings of the 4....20 mA interface at your indicating and evaluation unit and carry
out the respective scaling, if required.
Adjust the displayed values at the METPOINT
Notes
1. Until the indication of the first measured value, the value which was assigned to the 4 mA is displayed at the
start of the measurement.
2. During adjustments at the device (measurement is interrupted) no value is indicated.
3. When the device is deactivated, no values are indicated either.

13.6 Reading out of the measured values via the Ethernet connection

See separate operating instructions "METPOINT
METPOINT ® OCV
®
OCV and at your indicating unit so that they match.
®
OCV DATA-LOG".
Operation
65