Relay And Sensor On The Hipath 1120 - Siemens HiPath 1100 Service Manual

6.2.14

Relay and sensor on the HiPath 1120

Programmed Code
Functions
Sensor function 170
configuration
Sensor Activation 174
Logic
Time between 050
attempts for acti-
vating the sensor
MSN assignment 051
for the sensor
Number dialed by 052
sensor activation
Number of 053
attempts for acti-
vating the sensor
DTMF signals for 177
the sensor
*
Relay 175
Timer for deactivat- 173
ing the relay
External ring for 071
activating the relay
* When playing music from an external music source, all regulations relating to copyrights for the country in question have
to be followed.
Table 6-23 Relay and sensor on the HiPath 1120
Service Manual
Intermediate data
extension
Configuring the system specifically for the client
Table of the System's Programming Codes
Data to be
programmed
0 = Deactivate the
sensor's function (default)
1 = Dial the number speci-
fied in "Number dialed by
sensor activation" (Code
052).
2 = Activate the relay
through the sensor
3 = Detect DTMF code.
When this setting is
selected, the number that
was called must acknowl-
edge or ignore an alarm
call by sending an
acknowledgement code
("#" DTMF signal)
0 - Contacts closed
1 - Contacts open
Time: 00 to 10 minutes
Position: 001 to 140 or
∗
- to delete
Number (up to 20 digits)
001 to 100 (attempts)
Number (up to 20 digits)
# - To confirm
1 - Switch
2 - Monoflop
3 - Invert
4 - Music on Hold
5 - External signal
000 to 255
(intervals of 0.5 s)
Completing Default
data entry
Automatic 0
# instead of 0 - Contacts
the sensor closed
Automatic 03 (3
minutes)
Automatic None
Automatic or None
#
Automatic 001 (1
attempt)
Automatic or # None
Automatic 1 - Switch
# instead of 002 - (1
number second)
Automatic None
6-233