Siemens HiPath 1100 Service Manual page 272

Configuring the system specifically for the client
Comments about the system's programming codes
When only ISDN digital lines are being used, the following functions must be configured: DID, External number registration,
Area code, Country code.
MSN Automatic Internal Distribution
This features allows you to assign different MSN numbers for each S
to the type of S module. MSN numbers must be configured using the Manager tool (see Help file on Manager application).
0
ISDN telephones can be configured for any of the MSN numbers assigned to an S
out manually on each telephone set. The maximum number of MSNs allowed varies depending on the specific telephone mod-
el.
On the Gigaset SX255 you can assign many MSN numbers for each telephone using
the Manager tool. However, each set stores only the first 10 MSN numbers. For fur-
ther information on configuration and programming procedures for the Gigaset
SX255, refer to the Gigaset SX255 User's Manual (A31008-X255-B100-X-XX19).
Automatic MSN Assignment via Local Carrier
This is a subscription service enabled by a local carrier. When this facility is enabled external line MSNs can be automatically
registered.
On the Manager tool, when the Browse button is pressed (Basic -> MSN -> Settings -> Browse Button. For further information,
refer to the Help file), a message is sent to the local carrier requesting the MSNs. Once the carrier receives the message it
replies sending the MSNs which are then automatically entered into the system.
In order for all MSN numbers to be entered the remote seizure mode must be configured as PMP (Point-to-Multipoint) and the
system number must not have been specified in the Manager tool (Advanced->System Settings ->Regional Settings). If the
operating mode is PP (Point to Point), only the system number will be registered. You must configure MSN numbers (Basic-
>MSN->Settings). Any MSN number previously configured must be deleted.
Automatic MSN assignment facility provided by a local carrier only works if you also
subscribe to Call forwarding on the public network.
S Ports (HiPath 1190) (062)
0
This setting specifies the operating mode for the S0 module maximizing the system's port usage.
This option is best for the HiPath 1190 due to its high port capacity. The goal is to obtain a maximum number of extensions/
external lines allowed in relation to the following port detection rules:
External line and extension (default): Each port will decrease the number of external line slots by 2 and extension slots by 1.
The connection may be PP , PMP or S0 Bus line (see "Operation Mode")
External line only: Each port will decrease the number of external line slots by 2. The connection must be PP or PMP . If it has
been previously configured as an S0 Bus line, the connection will automatically revert to PP (which is the default).
Extension only: Each port will decrease the number of extension slots by 1. The connection must be a S0 Bus line. If it has
been previously configured as PP or PMP , the connection will automatically revert to S
After completing the configuration, the system must be restarted.
6-272
interface. The number of S
0
interface. The configuration must be carried
0
Bus line.
0
interfaces varies according
0
Service Manual