Configuring the system specifically for the client
Comments about the system's programming codes
Do not use a Serial or ADSL connection type while using HyperTerminal. During
●
ticketing the administration can be performed via USB connection, optiPoint, ISDN or
analog modem.
Tickets will only be shown after the end of the first connection.
●
To establish a serial or ADSL connection to the HiPath 1100 Manager, disconnect
●
HyperTerminal.
It is recommended that you uncheck the "Serial Printing" checkbox on the HiPath
1100 Manager if tickets are not being issued over an ADSL connection.
To provide accurate call details, you must update the system's time and date infor-
mation.
The following information is recorded:
Current date (Date)
●
End of call (Time)
●
External line used (Ln)
●
Note: Example of the (Ln) field content for ticketing:
External line
801
802
Extension (Ext)
●
Some specific types of access will be displayed in this field, indicated by the following numbers:
Sensor - Outgoing call
Data Link - Outgoing or incoming data call for system administration
DISA - Incoming call
Fax/DID - Incoming call
COS Changeover (WCOS)
●
Ring duration (Ring)
●
Call duration (Duration)
●
6-264
(Ln) Field
00
01
Access
(Ext) Field
9101
9201
9301
9401
Service Manual