Alarms And Messages In Manualturn Cycles; Error Handling In Cycles; Overview Of Cycle Alarms - Siemens SINUMERIK 840DE Operation & Programming Manual

11
Alarms and Messages

11.1 Alarms and messages in ManualTurn cycles

11.1

Alarms and messages in ManualTurn cycles

11.1.1 Error handling in cycles

11.1.2 Overview of cycle alarms

Alarm number
61101
61107
61244
61602
61604
61605
11-172
If an illegal status is recognized in the cycles an alarm is generated
and machining aborted.
Alarms 61000 to 62999 are generated in the cycles. The deletion
criterion for this range is NC_RESET. This aborts block preparation in
the NC. The error text that is displayed together with the alarm number
gives more detailed information about the cause of the fault.
The error numbers are classified as follows:
6
• X=0 General cycle alarms
• X=1 Deep hole drilling cycle alarms
• X=6 Turning cycle alarms
The table below lists all the errors that occur in the cycles, where they occur and
how they can be remedied.
Alarm text
"Reference plane
incorrectly defined"
"First drilling depth
incorrectly defined"
"Thread pitch change
causes undefined thread"
"Tool width incorrectly
defined"
"Active tool violates
programmed contour"
"Contour incorrectly
programmed"
_ X
Cycle Explanation, Remedy
Deep hole Either different values must be entered
drilling for the reference plane and return plane
for incremental definition of the depth or
an absolute value must be entered for
the depth.
Deep hole First drilling depth is not compatible with
drilling total drilling depth.
Thread cutting Check thread geometry.
Grooving in Grooving tool is larger than program-
STOCK med groove width
REMOVAL
Cutting in Contour violation in relief cut elements
STOCK caused by the clearance angle of the
REMOVAL tool used, i.e. use a different tool or
check the programmed contour
Cutting in Illegal relief cut element detected
STOCK
REMOVAL
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
11
08.02
_ _
© Siemens AG, 2002. All rights reserved