Siemens SINUMERIK 840DE Operation & Programming Manual page 103

5
08.02
5.3 Stock removal/grooving cycles in STOCK REMOVAL mode
Position parallel Z axis/
X axis
Machining mode
(alternative)
+
X0, Z0
X1, Z1
- α α α α 1 - α α α α 2
X - Z
m m
X , Z
m m
α α α α 1
α α α α 2
R , FS
n n
D
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
Explanation of parameters
You can define the stock removal position and the stock removal
direction in the coordinate system by means of these settings.
parallel zur Z-Achse (Längs) Parallel to X axis (longitudinal)
Innen
Außen External Internal
Z
X X
Z
X X
Select one of the following machining modes:
Roughing
Finishing
Complete machining (roughing and finishing)
Reference points for dimensioning
Final dimension (only the amount for "inc")
You can set the specified parameters to other combinations in this
parameter field.
Intermediate point (only the amount for "inc")
Angle of 1st path
Angle of 2nd path
Input of roundings and chamfers (n = 1 ... 3)
Infeed depth (enter without sign)
The maximum possible infeed depth for the roughing process is
defined in parameter D. The cycle automatically calculates the infeed
depth to be applied for roughing.
Turning with Cycles
parallel zur X-Achse (Plan)
Parallel to Z axis (plane)
Face end Stirnseite
Z Z
X X
Z Z
X X
5
Rückseite
Back plane
Z
Z
5-103